Vehicle-Specific Installation Notes

Rain Tracker Model: RT-50
Vehicle-Specific Installation Instructions
The instructions included with the product tell you how to install a Rain Tracker. This page gives special vehicle-specific information. Print this page using your browser's print function.

Application Vehicles
These instructions apply to these vehicles, which all have similar wiper systems:

JEEP CHEROKEE 92 - 96

Wiring Diagrams and Drawings:

1996 Jeep Cherokee- Drawing applies to all application vehicles listed above. Print this.
RT-50 - HSS (Hot Side Switching)- Included with product, so print only if needed.
Troubleshooting procedure- Print out if needed.

Wire colors used in this vehicle:

+12V - DT-GRN/BLK
GROUND - BLK
FAST - RED/BLK
SLOW - BRN/TAN

Special Rain Tracker Installation Notes for this vehicle:

Write the wire colors of the vehicle on the HSS drawing, and follow that
when you wire up the Rain Tracker. Use the factory drawing as a reference
to help you find the wires. Some models and years may vary slightly in wire colors.
Factory drawings can be wrong, so, confirm wire colors with a multimeter.

WIRE CONNECTIONS
All connections are available at the Intermittent Wiper Control Module. Models without
Intermittent Wipers wires can be accessed at the Wiper Switch. They can usually be accessed
by removing one or two access panels (Kick Panels.) Use chassis ground if a ground wire is
not available.

The Rain Tracker wiper control system works in parallel with the existing wiper system, so the existing manual control modes are not affected. This page generated by vehicle data file name: jeep_cherokee_92-96.veh