Vehicle-Specific Installation Notes

Rain Tracker Model: RT-50
Vehicle-Specific Installation Instructions
The instructions included with the product tell you how to install a Rain Tracker. This page gives special vehicle-specific information. Print this page using your browser's print function.

Application Vehicles
These instructions apply to these vehicles, which all have similar wiper systems:

FORD-TRUCK AEROSTAR VANS 86 - 97
FORD-TRUCK BRONCO 92 - 96
FORD-TRUCK ECONOLINE VAN E-150, E-250, E-350, E-450 92 - 04
FORD-TRUCK WINDSTAR 95 - 98
FORD-TRUCK PICKUP F-150 92 - 96
FORD-TRUCK PICKUP F-250, F-350, F-450, F-550, SUPERDUTY 92 - 97
MERCURY MOUNTAINEER 97 - 98

Wiring Diagrams and Drawings:

Ford TWM Wiper System - Non-Depressed Park- Drawing applies to all application vehicles listed above. Print this.
Troubleshooting procedure- Print if needed.

Wire colors used in this vehicle:

+12V - LOCATE
GROUND - CHASSIS
COMMON - BRN/WHT
MODE - ORN
RATE - DK-BLU/WHT

External Components Required for this installation

RESISTOR - 3.9K - Color Code: ORN-WHT-RED

Special Rain Tracker Installation Notes for this vehicle:

Use the instructions included in the Rain Tracker kit until you get to step 5a. "Make the interface
connections." At that point, use these instrctions along with the diagram that can be printed above.
Return to the general instructions when the interface connections has been completed.

Some models and years may vary slightly in wire colors. Confirm wire colors with service
guide, and/or with with a multimeter.

The FAST and SLOW wiper system wires are available at the wiper switch. They
can usually be accessed by removing one or two access panels (Kick Panels) and,
possibly, the shrouds surrounding the steering column. Locate +12V and GND.

FIND +12V
For Rain Tracker power (+12V), locate a source of power hot in accessory
or run. Power source should be min. 12-16ga. wire on a 15-25A circuit. This
can be one of the +12V sources as shown on the diagram, or some other accessory
source. The cigarette lighter is often a good +12V source.

FIND CHASSIS GROUND
Find a suitable screw or bolt on the metal chassis of the vehicle to use as the
Rain Tracker ground. Scrape away paint as needed for a good connection.
Use a multi-meter to verify that the ground connection is at most a few ohms.
The cigarette lighter can also be a good alternate for ground and/or power.

INTERFACE
These instructions are for vheicles that DO NOT have depressed park. That is, when the wipers are
off, they DO NOT move to a lower position below the hood. Use depressed park intructions if your
vehicle has a depressed park system.

Hydreon Corporation provides vehicle-specific installation information for over 5000 differen models of cars, vans, SUV's, and light trucks. This page generated by vehicle data file name: ford_twm_nd_c1.veh