Rain Tracker Model: RT-50
Vehicle-Specific Installation Instructions
The instructions included with the product tell you how to install a Rain Tracker.
This page gives special vehicle-specific information.
Print this page using your browser's print function.
Application Vehicles
These instructions apply to these vehicles, which all have similar wiper systems:
FORD CROWN VICTORIA 82 - 90
FORD TAURUS 86 - 89
FORD THUNDERBIRD 82 - 88
FORD-TRUCK ECONOLINE VAN E-150, E-250, E-350, E-450 82 - 91
LINCOLN CONTINENTAL 82 - 90
LINCOLN MARK VII 84 - 89
LINCOLN TOWN CAR 82 - 90
MERCURY COUGAR 82 - 88
MERCURY GRAND MARQUIS 82 - 90
MERCURY SABLE 86 - 89
Wiring Diagrams and Drawings:
Ford E-150 Van- Drawing applies to all application vehicles listed above. Print this.
Vehicles W/O Factory Intermittent- Print if vehicle has no factory intermittent
Troubleshooting procedure- Print if needed.
Wire colors used in this vehicle:
+12V - DK-GRN
GROUND - BLK
COMMON - YEL/RED
Special Rain Tracker Installation Notes for this vehicle:
Use the instructions included in the Rain Tracker kit until you get to step 5a. "Make the interface
connections." At that point, use these instrctions along with the diagram that can be printed above.
Return to the general instructions when the interface connections has been completed.
Some models and years may vary slightly in wire colors. Confirm wire colors with service
guide, and/or with with a multimeter.
VEHICLES WITH DEPRESSED PARK
The Rain Tracker will not work on vehicles with depressed park. There is no way, at least no easy way, to get the wipers out of park, and stay out of park, when the Rain Tracker is active.
The Rain Tracker wiper control system works in parallel with the existing wiper system, so the existing manual control modes are not affected. This page generated by vehicle data file name: ford_truck_e-150_van_91.veh
Copyright 2008 Hydreon Corporation All rights reserved.