Vehicle-Specific Installation Notes

Rain Tracker Model: RT-50
Vehicle-Specific Installation Instructions
The instructions included with the product tell you how to install a Rain Tracker. This page gives special vehicle-specific information. Print this page using your browser's print function.

Application Vehicles
These instructions apply to these vehicles, which all have similar wiper systems:

FORD MUSTANG 05 - 11

Wiring Diagrams and Drawings:

Ford Binary Wiper Systems, Color Scheme 8- Drawing applies to all application vehicles listed above. Print this.
Troubleshooting procedure- Print if needed.

Wire colors used in this vehicle:

+12V - LOCATE
GROUND - BLK/RED
LOGIC-A - DK-BLU/ORN
LOGIC-B - YEL/RED
LOGIC-C - RED
LOGIC-D - WHT

External Components Required for this installation

DIODE - 1N4004 - OR SIMILAR RECTIFIER
DIODE - 1N4004 - OR SIMILAR RECTIFIER

Special Rain Tracker Installation Notes for this vehicle:

Use the instructions included in the Rain Tracker kit until you get to step 5a. "Make the interface
connections." At that point, use these instrctions along with the diagram that can be printed above.
Return to the general instructions when the interface connections has been completed.

Some models and years may vary slightly in wire colors. Confirm wire colors with service
guide, and/or with with a multimeter.

All wiper system wires, except +12V, are available at the wiper switch. They
can usually be accessed by removing one or two access panels (Kick Panels) and,
possibly, the shrouds surrounding the steering column.

FIND +12V
For Rain Tracker power (+12V), locate a source of power hot in accessory
or run. Power source should be min. 12-16ga. wire on a 15-25A circuit. This
can be one of the +12V sources as shown on the diagram, or some other accessory
source. The cigarette lighter is often a good +12V source.

SYSTEM NOTES:
Some newer Mustangs may have the Ford Binary Color Scheme 7. Check with a multimeter
and/or a service manual. Color scheme 7 can be found here.

The Rain Tracker wiper control system works in parallel with the existing wiper system, so the existing manual control modes are not affected. This page generated by vehicle data file name: ford_binary_c8.veh