Rain Tracker Model: RT-50A
Vehicle-Specific Installation Instructions

The instructions included with the product tell you how to install a Rain Tracker.  This page gives special vehicle-specific information.  Print this page using your browser's print function.

Application Vehicles
     These instructions apply to these vehicles, which all have similar wiper systems:

FORD-TRUCK PICKUP F-150 04 - 08
LINCOLN MARK LT 06 - 07

Wiring Diagrams and Drawings:

Ford Binary Wiper System, Color Scheme 3- Drawing applies to all application vehicles listed above. Print this.
Troubleshooting procedure- Print if needed.

Wire colors used in this vehicle:

+12V - LOCATE
GROUND - BLK/LT-BLU
LOGIC-A - LT-BLU/ORN
LOGIC-B - YEL
LOGIC-C - PNK/BLK
LOGIC-D - PPL

External Components Required for this installation

DIODE - 1N4004 - OR SIMILAR RECTIFIER
DIODE - 1N4004 - OR SIMILAR RECTIFIER

Special Rain Tracker Installation Notes for this vehicle:

Use the instructions included in the Rain Tracker kit until you get to step 5a. "Make the interface
connections." At that point, use these instrctions along with the diagram that can be printed above.
Return to the general instructions when the interface connections has been completed.

Some models and years may vary slightly in wire colors. Confirm wire colors with service
guide, and/or with with a multimeter.

All wiper system wires, except +12V, are available at the wiper switch. They
can usually be accessed by removing one or two access panels (Kick Panels) and,
possibly, the shrouds surrounding the steering column.

FIND +12V
For Rain Tracker power (+12V), locate a source of power hot in accessory
or run. Power source should be min. 12-16ga. wire on a 15-25A circuit. This
can be one of the +12V sources as shown on the diagram, or some other accessory
source. The cigarette lighter is often a good +12V source.

MODEL YEARS
Please note that we have not seen the diagram for the 2008 F-150. We have previously documented
the F-150 through 2007. Since there was no major design change in 2008, we assume the 2008 has
the same wiper system. Therefore, it would be a good idea to consult a service manual before
installing on the 2008. Actually, we feel it is always good practice to check with a service
manual regardless.


The Rain Tracker wiper control system works in parallel with the existing wiper system, so the existing manual control modes are not affected.  This page generated by vehicle data file name: ford_binary_c3.veh

Copyright 2008 Hydreon Corporation All rights reserved.