Vehicle-Specific Installation Notes

Rain Tracker Model: RT-50
Vehicle-Specific Installation Instructions
The instructions included with the product tell you how to install a Rain Tracker. This page gives special vehicle-specific information. Print this page using your browser's print function.

Application Vehicles
These instructions apply to these vehicles, which all have similar wiper systems:

DODGE VIPER 92 - 02

Wiring Diagrams and Drawings:

2001 Dodge Viper- Print if needed.
Using the Rain Tracker to ground FAST or SLOW- Drawing applies to all application vehicles listed above. Print this.
Troubleshooting procedure- Included with product, so print only if needed.

Wire colors used in this vehicle:

+12V - LOCATE
GROUND - BLK/LT-GRN
GROUND FOR FAST - RED/YEL
GROUND FOR SLOW - BRN/WHT

External Components Required for this installation

ATUOMOTIVE RELAY - -

Special Rain Tracker Installation Notes for this vehicle:

All wiper system wires, except +12V, are available at the wiper switch. They
can usually be accessed by removing one or two access panels (Kick Panels) and,
possibly, the shrouds surrounding the steering column.

FIND +12V
For Rain Tracker power (+12V), locate a source of power hot in accessory
or run. Power source should be min. 12-16ga. wire on a 15-25A circuit. This
can be one of the +12V sources as shown on the diagram, or some other accessory
source. The cigarette lighter is often a good +12V source.

Use the instructions included in the Rain Tracker kit until you get to step 5a. "Make
the interface connections." At that point, use these instrctions along with the diagram
that can be printed above.

Some models and years may vary slightly in wire colors. If possible, confirm
wire colors with service guide, and/or with with a multimeter.

Wire the using both of the wiring diagrams shown below. Connect the S and F
points on the Ground fast OR slow drawing to the S and F points on the vehicle
wiring diagram.

The system works by grounding either the fast or slow outputs of the switch, fooling
the wiper control module into thinking that the user has selected those speeds.

The Rain Tracker wiper control system works in parallel with the existing wiper system, so the existing manual control modes are not affected. This page generated by vehicle data file name: dodge_viper_94-02.veh