Rain Tracker Model: RT-40A
Vehicle-Specific Installation Instructions
The instructions included with the product tell you how to install a Rain Tracker.
This page gives special vehicle-specific information.
Print this page using your browser's print function.
Application Vehicles
These instructions apply to these vehicles, which all have similar wiper systems:
DODGE VIPER 92 - 02
Wiring Diagrams and Drawings:
2001 Dodge Viper- Drawing applies to all application vehicles listed above. Print this.
RT-40A - GSS (Ground Side Switching)- Included with product, so print only if needed.
Troubleshooting procedure- Print out if needed.
Wire colors used in this vehicle:
+12V - LOCATE
GROUND - BLK/LT-GRN
GROUND FOR FAST - RED/YEL
GROUND FOR SLOW - BRN/WHT
Special Rain Tracker Installation Notes for this vehicle:
All wiper system wires, except +12V, are available at the wiper switch. They
can usually be accessed by removing one or two access panels (Kick Panels) and,
possibly, the shrouds surrounding the steering column.
FIND +12V
For Rain Tracker power (+12V), locate a source of power hot in accessory
or run. Power source should be min. 12-16ga. wire on a 15-25A circuit. This
can be one of the +12V sources as shown on the diagram, or some other accessory
source. The cigarette lighter is often a good +12V source.
Some models and years may vary slightly in wire colors. If possible, confirm
wire colors with service guide, and/or with with a multimeter.
The RT-40A does not utilize the FAST windings of the wiper motor. Please disregard any references
to FAST that appear in these instructions.
The Rain Tracker wiper control system features better rain sensing performance than many OE rain sensor systems. Hydreon Corporation tests all its products to exacting standards. This page generated by vehicle data file name: dodge_viper_94-02.veh
Copyright 2008 Hydreon Corporation All rights reserved.