Vehicle-Specific Installation Notes

Rain Tracker Model: RT-50A
Vehicle-Specific Installation Instructions
The instructions included with the product tell you how to install a Rain Tracker. This page gives special vehicle-specific information. Print this page using your browser's print function.

Application Vehicles
These instructions apply to these vehicles, which all have similar wiper systems:

CHRYSLER 300 05 - 07
CHRYSLER PT CRUISER 06 - 07
CHRYSLER TOWN & COUNTRY 08 - 10
DODGE AVENGER 08
DODGE CALIBER 07
DODGE CHARGER 06 - 07
DODGE MAGNUM 05 - 07
DODGE-TRUCK CARAVAN, GRAND CARAVAN 08 - 10
DODGE-TRUCK NITRO 07
DODGE-TRUCK RAM PICKUPS 09 - 12
JEEP LIBERTY 08 - 10
JEEP COMMANDER 06 - 07
JEEP GRAND CHEROKEE 05 - 14
JEEP WRANGLER 06 - 08

Wiring Diagrams and Drawings:

RT-50A - HSS/CAM (Hot Side Switching with CAM Feedback)- Print this.
Troubleshooting procedure- Print out if needed.
2005 Dodge Magnum- Drawing applies to all application vehicles listed above. Print this.

Wire colors used in this vehicle:

+12V - LOCATE
GROUND - CHASSIS
FAST - BRN/ORN
SLOW - BRN/WHT
CAM - BRN/GRY

Special Rain Tracker Installation Notes for this vehicle:

DIGITAL SWITCH SYSTEM
These vehicles have a digital switch system and require the use of the CAM Feedback Input
only available on the Rain Tracker model RT-50A.

Use the instructions included in the Rain Tracker kit until you get to step 5a. "Make
the interface connections." At that point, use these instrctions along with the diagram
that can be printed above. Return to the general instructions when the interface connections
have been completed.

Mount the Rain Tracker control module in the passenger compartment under inst. panel. Find
suitable power and ground. Extend the FAST, SLOW and CAM connections to the Rain Tracker
through the firewall to reach the wiper motor. Some models and years may vary slightly in wire colors.
Factory drawings can be wrong, so, confirm wire colors with a multimeter.

FIND +12V
For Rain Tracker power (+12V), locate a source of power hot in accessory or run. Power
source should be min. 12-16ga. wire on a 15-25A circuit. This can be one of the +12V
sources as shown on the diagram, or some other accessory source. The cigarette lighter is
often a good +12V source.

FIND CHASSIS GROUND
Find a suitable screw or bolt on the metal chassis of the vehicle to use as the Rain Tracker
ground. Scrape away paint as needed for a good connection. Use a multi-meter to verify that
the ground connection is at most a few ohms. The cigarette lighter can also be a good
alternate for ground and/or power.

WIRE CONNECTIONS
Dodge Caliber - FAST - BRN/LT-BLU

Jeep Wrangler - SLOW may be BRN/LT-BLU.

Dodge Ram Pickups - We received a diagram for the 2012 RAM Pickup 2500, so we assume, since there were no major design changes, that the wiper system is the same for all model years shown. Please check with a meter and/or service manual to verify.

Some vehicles the CAM wire may be BRN.

The Rain Tracker wiper control system is compatible a wide range of windshield transmittances and thicknesses This page generated by vehicle data file name: dodge_magnum_05.veh