Vehicle-Specific Installation Notes

Rain Tracker Model: RT-50A
Vehicle-Specific Installation Instructions
The instructions included with the product tell you how to install a Rain Tracker. This page gives special vehicle-specific information. Print this page using your browser's print function.

Application Vehicles
These instructions apply to these vehicles, which all have similar wiper systems:

MAZDA 626 82 - 92
MAZDA 323 86 - 89
MAZDA 929 88 - 91
MAZDA GLC 82 - 85
MAZDA MX-5 MIATA 90 - 07
MAZDA MX-6 88 - 92
MAZDA RX7 82 - 91
MAZDA-TRUCK CX-9 07

Wiring Diagrams and Drawings:

1990 Mazda 626- Drawing applies to all application vehicles listed above. Print this.
RT-50A - GSS (Ground Side Switching)- Included with product, so print only if needed.
Troubleshooting procedure- Print out if needed.

Wire colors used in this vehicle:

+12V - BLU
GROUND - BLK
FAST - BLU/RED
SLOW - BLU/WHT

Special Rain Tracker Installation Notes for this vehicle:

Write the wire colors of the vehicle on the GSS drawing, and follow that
when you wire up the Rain Tracker. Use the factory drawing as a reference
to help you find the wires. Some models and years may vary slightly in wire colors.
Factory drawings can be wrong, so, confirm wire colors with a multimeter.

All wiper system wires are available at the wiper switch. They can usually be accessed
by removing one or two access panels (Kick Panels) and, possibly, the shrouds surrounding the
steering column.

WIRE CONNECTIONS
2006-2007 Miata, FAST - BLK/BLU and SLOW - BLK/YEL.
2007 CX-9, +12V is BLU/YEL

Some models (i.e. 929 & GLC) may not have a +12V wire coming from the switch.
In this case, a suitable +12V that is hot in ACC/RUN will need to be found.
The cigarette lighter is generally a good choice. Use a multimeter to check.

The Rain Tracker wiper control system works in parallel with the existing wiper system, so the existing manual control modes are not affected. This page generated by vehicle data file name: mazda_626_88-92.veh