Vehicle-Specific Installation Notes

Rain Tracker Model: RT-50A
Vehicle-Specific Installation Instructions
The instructions included with the product tell you how to install a Rain Tracker. This page gives special vehicle-specific information. Print this page using your browser's print function.

Application Vehicles
These instructions apply to these vehicles, which all have similar wiper systems:

HYUNDAI SCOUPE 91 - 95

Wiring Diagrams and Drawings:

1991 Hyundai Scoupe- Drawing applies to all application vehicles listed above. Print this.
RT-50A - GSS (Ground Side Switching)- Included with product, so print only if needed.
Troubleshooting procedure- Print out if needed.

Wire colors used in this vehicle:

+12V - LOCATE
GROUND - BLK
FAST - RED/BLK
SLOW - YEL/BLK

Special Rain Tracker Installation Notes for this vehicle:

Write the wire colors of the vehicle on the GSS drawing, and follow that
when you wire up the Rain Tracker. Use the factory drawing as a reference
to help you find the wires. Some models and years may vary slightly in wire colors.
Factory drawings can be wrong, so, confirm wire colors with a multimeter.

All wiper system wires, except +12V, are available at the wiper switch. They
can usually be accessed by removing one or two access panels (Kick Panels) and,
possibly, the shrouds surrounding the steering column.

FIND +12V
For Rain Tracker power (+12V), locate a source of power hot in accessory
or run. Power source should be min. 12-16ga. wire on a 15-25A circuit. This
can be one of the +12V sources as shown on the diagram, or some other accessory
source. The cigarette lighter is often a good +12V source.

The Rain Tracker wiper control system is compatible a wide range of windshield transmittances and thicknesses This page generated by vehicle data file name: hyundai_scoupe_91.veh