Vehicle-Specific Installation Notes

Rain Tracker Model: RT-50A
Vehicle-Specific Installation Instructions
The instructions included with the product tell you how to install a Rain Tracker. This page gives special vehicle-specific information. Print this page using your browser's print function.

Application Vehicles
These instructions apply to these vehicles, which all have similar wiper systems:

HYUNDAI ACCENT 10 - 13

Wiring Diagrams and Drawings:

2013 Hyundai Accent- Drawing applies to all application vehicles listed above. Print this.
RT-50A - HSS (Hot Side Switching)- Included with product, so print only if needed.
Troubleshooting procedure- Print out if needed.

Wire colors used in this vehicle:

+12V - BRN
GROUND - BLK
FAST - WHT
SLOW - GRN

Special Rain Tracker Installation Notes for this vehicle:

Write the wire colors of the vehicle on the HSS drawing, and follow that
when you wire up the Rain Tracker. Use the factory drawing as a reference
to help you find the wires. Some models and years may vary slightly in wire colors.
Factory drawings can be wrong, so, confirm wire colors with a multimeter.

All wiper system wires are available at the wiper switch. They can usually be accessed
by removing one or two access panels (Kick Panels) and, possibly, the shrouds surrounding the
steering column.

MODEL YEARS
Please note that we received the diagram for the 2013 Accent from a customer. We have previously
documented the Accent through 2009. Since the 2010 model year was a major design change and 2013
is part of the same generation, we assume 2010 through 2013 are the same wiper system. Therefore,
it would be a good idea to consult a service manual before installing. Actually, we feel it is
always good practice to check with a service manual regardless.

The Rain Tracker wiper control system works in parallel with the existing wiper system, so the existing manual control modes are not affected. This page generated by vehicle data file name: hyundai_accent_13.veh